CDI Torque 10005CF-II 1 In Dr Computorq II Electronic Torque Wrench 100-1000 ft/lb

Home > Measurement Tools > Torque Wrenches > CDI Torque 10005CF-II 1 In Dr Computorq II Electronic Torque Wrench 100-1000 ft/lb

Share |

Largest Storage Capacity Available - Up to 4000 torque values can be stored in memory. An audible tone signals when memory is full.
Down Loading Capacity - Computorq II is equipped to down-load individual torque values or store values in memory which can be directly down-loaded to a printer/computer or datalogger via RS232.
Selectable Modes of Operation - "Peak Hold" and "Track" modes of operation are standard. Computorq II`s electronics are far superior to our competitors in capturing real torque value in "Peak" mode.
Easy Set-Up - Target torque values (high and low percentage, +/- tolerances and torque engineering units) are easily programmed through the keypad and shown on the LCD.
Quality Construction - Proven industrial quality. Designed for continuous use.
Batteries - A 9V alkaline battery is standard and provides enough power for 60 hours of operation. A "LO BAT" indication on the display signals for replacement.
Accuracy - +/- 1% From 20-100% of scale +/- 1%, plus 5 increments, from 10 -20% of scale.
Calibration Data - All calibration data is stored in the microprocessor.
Baud Rate - The baud rate for downloading to a printer/computer/data logger is selectable. The factory set rate is 1200. Options are 300, 600, 1200 2400, 4800, 9600 or 19,200.

Specs
Range: 100-1000 Ft/Lb (135-1355 Nm, 14-138 mkg)
Increments: .1 Ft/Lb (.1Nm, .1 mkg)
Length: 74.0"
Weight: 19.0 Lbs.

Computorq II wrenches are equipped with both audio and visual signals in addition to the torque information supplied on the LCD.
Audio Signal - An audio signal is emitted when the minimum acceptable standard indicators of high and low preset torque value is reached or the upper torque limit is exceeded.
Visual Indicators - Bright green and red LED`s are standard indicators of high and low preset torque limits.
Over-Load Protection - The red LED flashes, the audio buzzer sounds and "OVER" is displayed on the LCD when the torque range of the wrench is exceeded.
New Liquid Crystal Display - Large sized Super Twist liquid crystal display incorporates technology improving visibility of displayed data from any viewing angle. The display is updated five times a second for changes in torque measurements. There is no perceived lag between applying torque and updating the measurements on the LCD. It is the fastest on the market.
Engineering Units - All seven basic engineering torque units are available on most Computorq 11 models (Ft. Lb., In. Lb., In. Oz., Nm, dNm, Mkg, or cmkg) and are easily selected through the keypad.
Displayed Torque Measurements - Torque measurements captured on the display remain until they are erased, sent to the wrench`s memory, or down-loaded to an external device.
New Embossing Membrane Keypad Features: On/Off Switch, Sleep Mode, Recall of Torque Measurements, Recall Display, Bar Graph and Directional Indicators.